Monitoring Storm Control; Information About Protected Ports; Protected Ports - Cisco Catalyst 2960-XR Security Configuration Manual

Monitoring Storm Control

Command or Action
Step 5
end
Example:
Switch(config-if)# end
Step 6 show storm-control [interface-id]
[broadcast | multicast | unicast]
Example:
Switch# show storm-control
gigabitethernet1/0/1 unicast
Step 7 copy running-config startup-config
Example:
Switch# copy running-config
startup-config
Monitoring Storm Control
Table 30: Commands for Displaying Storm Control Status and Configuration
Command
show interfaces [interface-id] switchport
show storm-control [interface-id] [broadcast
| multicast | unicast]

Information About Protected Ports

Protected Ports

Some applications require that no traffic be forwarded at Layer 2 between ports on the same switch so that
one neighbor does not see the traffic generated by another neighbor. In such an environment, the use of
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
330
Purpose
Returns to privileged EXEC mode.
Verifies the storm control suppression levels set on the interface for the specified
traffic type. If you do not enter a traffic type, broadcast storm control settings are
displayed.
(Optional) Saves your entries in the configuration file.
Purpose
Displays the administrative and operational status of all
switching (nonrouting) ports or the specified port, including
port blocking and port protection settings.
Displays storm control suppression levels set on all interfaces
or the specified interface for the specified traffic type or for
broadcast traffic if no traffic type is entered.
Configuring Port-Based Traffic Control
OL-29434-01