Cisco Catalyst 2960-XR Security Configuration Manual page 266

Default 802.1x Authentication Configuration
Feature
AAA
RADIUS server
• IP address
• UDP authentication port
• Key
Host mode
Control direction
Periodic re-authentication
Number of seconds between
re-authentication attempts
Re-authentication number
Quiet period
Retransmission time
Maximum retransmission number
Client timeout period
Authentication server timeout period
Guest VLAN
Inaccessible authentication bypass
Restricted VLAN
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
244
Configuring IEEE 802.1x Port-Based Authentication
Default Setting
Disabled.
• None specified.
• 1812.
• None specified.
Single-host mode.
Bidirectional control.
Disabled.
3600 seconds.
2 times (number of times that the switch restarts the authentication
process before the port changes to the unauthorized state).
60 seconds (number of seconds that the switch remains in the quiet
state following a failed authentication exchange with the client).
30 seconds (number of seconds that the switch should wait for a
response to an EAP request/identity frame from the client before
resending the request).
2 times (number of times that the switch will send an
EAP-request/identity frame before restarting the authentication
process).
30 seconds (when relaying a request from the authentication server
to the client, the amount of time the switch waits for a response
before resending the request to the client.)
30 seconds (when relaying a response from the client to the
authentication server, the amount of time the switch waits for a
reply before resending the response to the server.)
You can change this timeout period by using the dot1x timeout
server-timeout interface configuration command.
None specified.
Disabled.
None specified.
OL-29434-01