Setting The Switch-To-Client Frame-Retransmission Number - Cisco Catalyst 2960-XR Security Configuration Manual

Setting the Switch-to-Client Frame-Retransmission Number

Command or Action
Step 4
end
Example:
Switch(config-if)# end
Step 5 show authentication sessions interface interface-id
Example:
Switch# show authentication sessions interface
gigabitethernet2/0/1
Step 6 copy running-config startup-config
Example:
Switch# copy running-config startup-config
Setting the Switch-to-Client Frame-Retransmission Number
In addition to changing the switch-to-client retransmission time, you can change the number of times that the
switch sends an EAP-request/identity frame (assuming no response is received) to the client before restarting
the authentication process.
Note You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
Beginning in privileged EXEC mode, follow these steps to set the switch-to-client frame-retransmission
number. This procedure is optional.
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. dot1x max-reauth-req count
4. end
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
262
Configuring IEEE 802.1x Port-Based Authentication
Purpose
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
OL-29434-01