Analog Out Menu - Sony BRC-300P Operating Instructions Manual

DISPLAY INFO
When the camera settings are stored in POSITION 1 to
6 using the supplied Remote Commander (page 34), the
message "PRESET No. xx" automatically appears for 2
seconds on the monitor screen. If you want to display the
message each time the camera is operated, set DISPLAY
INFO to ON. Set it to OFF to cancel the display.
30

ANALOG OUT Menu

ANALOG OUT Menu
The ANALOF OUT menu appears only when the
BRBK-301 Anaolog RGB Component card is installed
in the card slot of the camera.
< A N A L O G O U T >
> O U T P U T 1
S Y N C
O U T P U T 2
OUTPUT 1
Select the signal output from pins 3, 4 and 5 of the 9-pin
D-sub connector of the Analog RGB Component Card.
Set to RGB for the RGB signal output, or YCrCb for the
component signal output.
When RGB is selected, SYNC appears, and you can
select the sync signal from among G, RGB, and OFF.
OUTPUT 2
Select the signal output from pin 6 of the 9-pin D-sub
connector of the Analog RGB Component Card.
Set to VBS for the composite signal output, or Y/C for
the S video signal output.
R G B
G
V B S