Appendix; List Of Messages - Sony BRC-300P Operating Instructions Manual

Appendix

List of Messages

The following messages may appear on the screen. Take
the necessary measures shown below.
Indicators on the BRC-300/300P camera
Indicator Meaning/remedies
STANDBY lamp The camera stopped moving due to an
flashes. error in the pan/tilt mechanism. Reset
the pan/tilt position or turn off the power
of the camera and turn it on again.
The tally lamp Turn off the power of the camera, and
flashes. consult with your Sony dealer.
Messages for the BRC-300/300P camera
Message Meaning/remedies
Please restart system You are prompted to restart the power of
the camera after you changed the setting
of "IMG-FLIP" in the SYSTEM menu or
"D-ZOOM" in the PAN TILT ZOOM
menu.
Use the POWER switch on the supplied
Remote Commander or the POWER
button on the RM-BR300 Remote
Control Unit to turn the power off, then
on. The changed setting becomes
effective.
PRESET xx OK When you store the camera settings into
(xx = 1 to 6) the memory (POSITION 1-6), the
message will appear for 2 seconds.
White balance active While the white balance adjustment is
automatically adjusted, the message will
blink. Wait for a while. When the
adjustment is complete, it will disappear.
White balance active The message will appear only when you
Please wait activate the one-push white balance
adjustment by pressing the ONE PUSH
AWB button on the RM-BR300 Remote
Control Unit.
Error messages for the BRU-300/300P Optical
Multiplex Unit
Message Meaning/remedies
Communication error The message will appear when the
Please check Optical Multiplex Unit is turned on, if a
connection problem occurs in the connection of the
Optical Fiber Cable between the camera
and the Optical Multiplex Unit. Turn off
the power of the camera and the Optical
Multiplex Unit, check the connection of
the Optical Fiber Cable and turn the
power on again.
Option card error The message will appear when same-
Please check option
type interface cards are inserted into the
card two card slots on the Optical Multiplex
Unit. Turn off the power of the Optical
Multiplex Unit and remove either of the
cards.
57
List of Messages