Video Out Menu - Sony BRC-Z700 Operating Instructions Manual

DISPLAY INFO (information display)
When the camera settings are stored in POSITION 1 to
16 using the supplied Remote Commander or the RM-
BR300 Remote Control Unit, the message "PRESET
No. xx" automatically appears for 2 seconds on the
monitor screen. If you want to display the message each
time the camera is operated, set DISPLAY INFO to ON.
Set it to OFF to cancel the display.
Note
The message will appear if the built-in cooling fan of the
camera has accidentally stopped. When DISPLAY
INFO is set to OFF, the display of this message is also
canceled.
SYNC MASTER
When you connect a sync signal generator, you can
select an output video signal that is synchronized with
the external video sync signal input to the EXT SYNC
IN connector on the camera from among the following
output signals:
STD (HD): Selects the output signal from the
RGB/COMPONENT connector on the camera.
STD (SD): Selects the output signal from the
VIDEO or S VIDEO connector on the camera.
HD 1: Selects the output signal from the HFBK-HD1
HD Interface Board inserted in the BRU-H700 HD
Optical Multiplex Unit.
SD 1: Selects the output signal from the HFBK-SD1 SD
Interface Board inserted in the BRU-H700 HD
Optical Multiplex Unit.
Note
When the BRU-H700 HD Optical Multiplex Unit is
connected to the camera, STD (SD) is not available and
an output video signal from the
VIDEO connector is not synchronized with an external
video sync signal.
H PHASE
When you connect a sync signal generator, adjust the
horizontal phase so that the output signal is
synchronized with the external sync signal input to the
camera. The adjustable range is from 0 to 140.
When you select H PHASE in the menu, the color bar is
displayed on the screen. Then perform the H PHASE
adjustment.
After completing the adjustment, press the HOME
button on the Remote Commander or the button on the
top of the joystick on the Remote Control Unit to make
the color bar disappear.
Note
The H PHASE adjustment is not available when the
BRU-H700 HD Optical Multiplex Unit is connected to
the camera.

VIDEO OUT Menu

HD-RGB/COMPONENT
FORMAT
Select the signal output from the
COMPONENT connector on the camera.
YPbPr: Outputs analog component signals.
RGB: Outputs RGB signals.
ADD SYNC
Appears when RGB is selected with FORMAT and
specifies whether to add a sync signal.
RGB: Outputs each R, G and B signal with a sync signal
OFF: Outputs each R, G and B signal with no sync
SYNC TYPE
Appears when either RGB or YPbPr is selected with
FORMAT and specifies the type of a sync signal.
VIDEO or S
VD: Outputs the bi-level sync.
SD-VIDEO/S VIDEO
IMG SIZE
Select the aspect ratio of the signal output from the
VIDEO or
16:9[LETTER]: The image is displayed in 16:9
4:3[CROP]: The image is displayed in 4:3 edge crop.
4:3[SQUEEZE]: The image is displayed in 4:3
SETUP
Select whether 7.5IRE setup is added to output signals.
ON: Outputs signals with 7.5IRE setup added.
OFF: Outputs signals with no 7.5IRE setup added.
< V I D E O O U T >
H D - R G B / C O M P O N E N T
> F O R M A T
S Y N C T Y P E
S D - V I D E O / S V I D E O
I M G S I Z E 1 6 : 9 [ L E T T E R ]
S E T U P
added.
signal added.
SYNC: Outputs the tri-level sync.
S VIDEO connector on the camera.
letterbox.
squeeze.
Y P P
b r
S Y N C
O F F
RGB/
37
VIDEO OUT Menu