Installation And Connections; Installation; Attaching An Interface Card; Installing The Camera - Sony BRC-300P Operating Instructions Manual

Installation and Connections

Installation

Attaching an Interface Card

Attach an interface card (not supplied) to the card slot on
the rear of the camera.
1
Loosen the two screws to remove the card slot
cover.
2
Insert an optional interface card into the card slot.
Align both ends of the interface card with the
sliders inside the slot, then insert the card securely
as far as it will go.
42
Installation
3
Tighten the two screws on the interface card.
To remove the interface card
Loosen the two screws on the interface card and pull the
card out straight and slowly.

Installing the Camera

To install the camera on a desk
Place the camera on a flat surface.
If you have to place the camera on an inclined surface,
make sure that the inclination is less than ±15 degrees,
so that the pan/tilt performance is guaranteed.
Notes
• You should take an appropriate countermeasure to
prevent the camera from falling.
• Do not grasp the camera head when carrying the
camera.
• Do not turn the camera head by hand. Doing so will
result in the camera malfunctioning.
Interface card
(not supplied)