Table of Contents
Advertisement
11 Complete Installation
Before completing the installation you should test the sensor. If needed, adjust the sensor as necessary.
1.
Test that the sensor releases the security device when activated.
2.
Test the activation height of the sensor.
3.
Test the activation zone parallel to the door and in front of the door handle.
When completely finished with adjustments, reinstall the lens and the right end cap.
12 Troubleshooting
PROBLEM
R2E-100 is detecting erratically
Bosch sensor is being replaced on an
existing installation by a R2E-100
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or
modifications not expressly approved by BEA Inc. could void the user's authority to use this equipment.
Patent Pending
BEA INSTALLATION/SERVICE COMPLIANCE EXPECTATIONS
BEA Inc., the sensor manufacturer, cannot be held responsible for incorrect installations or inappropriate adjustments or the sensor/device; therefore, BEA Inc. does not
guarantee any use of the sensor outside its intended purpose.
BEA Inc. strongly recommends that installation and service technicians be AAADM-certifi ed for pedestrian doors, IDA-certifi ed for doors/gates, and factory-trained for
the type of door/gate system.
Installers and service personnel are responsible for executing a risk assessment following each installation/service performed, ensuring that the sensor system installation
and/or device is compliant with local, national, and international regulations, codes, and standards.
Once installation or service work is complete, a safety inspection of the system should be performed and documented per the manufacturers recommendations, or
industry guidelines. Examples of compliance may apply to ANSI 156.10, ANSI 156.19, ANSI/DASMA 102, ANSI/DASMA 107, UL294, International Building Code.
Tech Support: 1-800-407-4545 | Customer Service: 1-800-523-2462 | General Tech Questions: Tech_Services@beainc.com | Tech Docs: www.BEAinc.com
©BEA
©BEA
| Original Instructions
| Original Instructions
75.5644.09 R2E-100 20181009
75.5644.09 R2E-100 20181009
PROBABLE CAUSE
Sensor's IR beams are reflecting off the
door handle
CORRECTIVE ACTION
Adjust the sensor so that the beams are in front of the
handle.
See BEA Application Note.
Page 7 of 10
Page 7 of 10
Advertisement
Table of Contents
