Table of Contents
Advertisement
Troubleshooting
Vacuum motor and Pump do not work
WARNING:
To reduce the risk
of fire, electric
shock or injury
unplug appliance
from outlet
before servicing.
Reduced spray or no spray / Leaking connections
Vacuum not picking up cleaning solution
Dry vacuum not picking up dust/dirt
12
Possible Causes
Vacuum is off or not plugged in
Collection Tank is full
Air leak
Kink/blockage in hoses/tubes
Possible Causes
Spray Nozzle clogged
Solution Supply Tank empty
Wand Solution Tube disconnected
Pump not operating properly
Vacuum Hose Assembly loose
Possible Causes
Loose Wand/Cleaning Nozzle
Lid not seated correctly
Poor Cleaning Nozzle position
Collection Tank is full
Foam Filter is dirty
Possible Causes
Loose Wand/Floor Brush
Lid not Seated correctly
Foam Filter is dirty
Dust Bag is full
Remedies
Check electrical plug
Vacuum/switch on?
Empty Collection Tank
Check all vacuum connections
Secure all latch buttons
Straighten hoses/tubes
Check aluminum wands/
Flex Hose/Wand Solution Tube
for obstructions
Call BISSELL Consumer Services
(see page 14)
Remedies
Clean Spray Nozzle
Refill Tank
Tighten loose connections
Relax kinks in solution tubes/hoses
Check electrical plug
Pump switch on?
Check fit of Suction Fitting to Suction Inlet
Call BISSELL Consumer Services
(see page 14)
Remedies
Check and tighten connections
Lift and relatch
Try better angle, apply more downward
pressure on Grip/Trigger Unit
Empty Collection Tank
Clean and replace
Remedies
Check and tighten connections
Lift and relatch
Clean and replace
Replace with new Paper Dust Bag
Advertisement
Table of Contents
