Table of Contents
Advertisement
How to clean upholstery and small areas
Tip:
Check upholstery
stuffing before
cleaning.
Colored stuffing
may bleed
through fabric
when wet.
Getting ready
You will not need the Wand Solution Tube for this procedure.
1. Attach Squeegee by inserting wand into Squeegee and
pushing Squeegee on with a slight twisting motion.
Cleaning
1. Move Power switch to ON position.
2. Place Squeegee at farthest extent of spill and pull slowly
toward you through the spill, allowing vacuum to pick
up liquid.
3. If the cleaner stops picking up liquid and the vacuum
motor increases in pitch the Collection Tank may be full.
Empty the Collection Tank and resume vacuuming.
4. See WHEN YOU'RE DONE, page 8 and PUTTING IT AWAY,
page 11.
Getting ready
1. Disconnect Wand Solution Tube and aluminum wands from
Grip/Trigger unit of Flex Hose Assembly.
2. Position Wand Solution Tube Connector (with lock slot)
of Small Area/Upholstery Cleaning Nozzle near Wand
Solution Tube Connection (with lock pin) of Grip/Trigger
Unit, as shown.
3. Slide Connector over connection, engaging slot over pin.
4. While pressing inward, turn Connector clockwise until pin
snaps into slot.
IMPORTANT: Wand Solution Tube must lock firmly over
Connection to prevent leakage.
5. Check manufacturer's tag and/or test fabric in an
inconspicuous place.
Cleaning
1. Fill Solution Supply Tank with water and approved cleaner
for upholstery.
2. Move Power switch to ON position.
3. Move Pump switch to ON position.
4. Depress trigger and pull cleaning nozzle toward you.
3. Release trigger and repeat action to extract excess moisture.
4. Repeat until area is clean.
5. See WHEN YOU'RE DONE, page 8 and PUTTING IT AWAY,
page 11.
How to pick up wet spills
WARNING:
Do
not pick up flammable
or combustible materials
(lighter fluid, gasoline,
kerosene, etc.) or use in
the presence of explosive
liquids or vapor.
Do not pick up toxic
material (chlorine bleach,
ammonia, drain cleaner,
gasoline, etc.)
9
Advertisement
Table of Contents
