Dry Vacuuming - Bissell Big Green Ultra 16753 User Manual

1. Connect one of three tools (Crevice Tool, Dusting Brush,
Floor Brush) to wand. Place tool over wand and push
on with a slight twisting motion.
2. Attach wand to Grip/Trigger Unit using
"button-in-hole" method.
3. Attach Flex Hose Assembly to Cleaner Body.
4. Open Lid, grasp Carry Handle, and remove
Solution Container.
5. Fold Paper Dust Bag (use only BISSELL Envirofresh
Dust Bag).
6. Locate Dust Bag Connection on underside of Lid and
position Bag as shown.
7. With Cardboard Collar facing Lid, insert Collar Notches
into two (2) tabs as shown.
8. Unfold Bag into Cleaner Body cavity.
9. Press top of collar to engage Upper Lock Tab. Collar will
snap into place when correctly seated.
10. Close Lid securely.
11. Plug Power Cord into 120 Volt, 60 Hz grounded outlet
as described in Important Safety Instructions, page 2.
If cleaner starts when first plugged in, switch cleaner off
until ready for use.
12. Move Power switch to ON position.
NOTE: For best results, use a slow back and forth motion
for dry surface cleaning.
When you're done
1. Move Power switch to OFF position.
2. Unplug Power Cord from outlet.
3. To prepare cleaner for wet cleaning, remove Paper Dust
Bag and replace Solution Container.
ALWAYS remove Paper Dust Bag before wet cleaning.
Dust bag replacement
Always discard full Dust Bag. NEVER reuse a Dust Bag.
Use Only (BISSELL Envirofresh Dust Bag).
1. Raise Lid.
2. Push top Lock Tag upward to release Bag Collar.
3. Raise Collar clear of Lock Tab and slide upwards to
remove Dust Bag.
10
How to dry vacuum
Tip:
Check Foam
Filter before

dry vacuuming.

Clean if
necessary.