Dry Vacuuming - Bissell Total Floors® Wet & Dry Hard Floor Cleaner 2949 User Manual

O
perations

Dry Vacuuming

With the dry side of the unit facing forward,
turn the unit on and begin cleaning.
you will see dry dirt, crumbs and debris being
collected in the collection tank. you do not have
to empty the dry debris before wet cleaning.
Flipping From Dry to Wet Cleaning
to change from dry vacuuming to wet cleaning
simply flip the unit around!
the gentle clean™ brush or Pad and
squeegee will automatically be lowered to
effectively clean and dry all your Hard floor
surfaces.
Wet Cleaning/Vacuuming
to begin Wet cleaning, simply depress the
spray trigger. Water and formula will be
dispensed through the gentle clean™ brush
or Pad.
to maximize the area to be cleaned, depress
the spray trigger on the forward stroke and
release on the reverse stroke.
this will dispense water and formula going
forward and on the pull back, the squeegee
will leave the floor essentially dry and ready
to walk on.
Collection Tank is Full
While Wet cleaning, you will see dirty water
collected in the collection tank. When the tank
is full, the white float in the collection tank will
rise to the top, making a noticeable sound to let
you know it is time to empty the collection tank.
suction will stop when tank is full of water.
w w w . b i s s e l l . c o m
Tip:
to extend the life of your filter
and to maintain maximum dry
suction, check the filter for lint
and debris frequently.
Tip:
to make sure water and
formula are flowing, depress
the spray trigger without the
gentle clean™ brush or Pad
inserted. you should see a light
stream of water and formula
dispensed unto the floor.
8 0 0 . 2 3 7 . 7 6 9 1
7