ActionTec Broadband Router RI408 User Manual page 70

Chapter 5 Configuring the Router's Security
• PPTP connection - a packet inquiring whether the Router is ready to
receive a connection has been accepted.
PPTP
• AUTH:113 request - an outbound packet for
accepted (for maximum security level).
• IPV6 over IPV4 - an
• ARP - an packet has been accepted.
ARP
• PPP Discover - a
• PPP Session - a
• 802.1Q - a 802.1Q (
• Outbound Auth1X - an outbound Auth1X packet has been accepted.
• IP Version 6 - an
• Router initiated traffic - all traffic the Router initiates is recorded.
• Maximum security enabled service - a packet has been accepted because it
belongs to a permitted service in the maximum security level.
• SynCookies Protection - a SynCookies packet has been blocked.
• ICMP Flood Protection - a packet has been blocked, stopping an
flood.
• UDP Flood Protection - a packet has been blocked, stopping a
• Service - a packet has been accepted because of a certain service, as specified
in the event type.
• Advanced Filter Rule - a packet has been accepted/blocked because of an
advanced filter rule.
• Fragmented packet, header too small - a packet has been blocked because,
after defragmentation, the header was too small.
• Fragmented packet, header too big - a packet has been blocked because,
after defragmentation, the header was too big.
• Fragmented packet, bad align - a packet has been blocked because, after
defragmentation, the packet was badly aligned.
v6 over v4 packet has been accepted.
IP IP
discover packet has been accepted.
PPP
session packet has been accepted.
PPP
) packet has been accepted.
VLAN
v6 packet has been accepted.
IP
67
protocol has been
AUTH
UDP
ICMP
flood.