Table of Contents
Advertisement
2. The "Blocked Website" screen appears. Enter the website address (
to block on the network (all pages within the website will also be blocked). If
the website address has multiple
tional addresses and automatically add them to the restrictions table.
3. To apply website blocking to a single computer or group of computers on the
network, select them from the "Networked Computer/Device" drop-down list.
4. If website blocking needs to be active all the time, select "Always" from the
"When should this rule occur?" drop-down list. If the rule will only be active at
certain times select "Specify Schedule" and click Add. Then, add a schedule rule
(for more details about schedule rules, see the "Advanced Settings" chapter of
this manual).
☞
Note: Make sure the Router's date and time settings for current
time zone are set correctly.
5. Click Apply to add the website to the table. The previous screen appears while
the Router attempts to find the site. "Resolving..." appears in the "Status" col-
umn while the site is being located.
6. If the site is successfully located, "Resolved" appears in the Status column. If
not, "Hostname Resolution Failed" appears. Click Refresh to update the status
if necessary. If the Router fails to locate the website, do the following:
• Use a web browser to verify the website is available. If it is, the website
address was entered incorrectly.
• If the website is not available, return to the Website Blocking screen at a
later time and click Resolve Now to verify the website can be found and
blocked by the Router.
Chapter 3 Configuring My Network Settings
addresses, the Router will resolve all addi-
IP
17
or
)
IP
URL
Advertisement
Table of Contents
