ActionTec Broadband Router RI408 User Manual page 32

DNS Server
Domain Name System (
are translated into
the information provided by the
To manually configure
Server Addresses. Specify up to two different
mary, the other secondary.
IP Address Distribution
The " Address Distribution" section of the Configure Network (Home/Office)
IP
screen is used to configure the Router's Dynamic Host Configuration Protocol
( ) server parameters.
DHCP
work devices. If enabled, make sure to configure the network devices as "
Clients." There are three options in this section: Disabled, DHCP Server, and
DHCP Relay.
Disabled Select this option if statically assigning
devices.
DHCP Server To set up the network bridge to function as a
1. Select DHCP Server.
2. Enter the
address at which the Router starts issuing addresses in the
IP
"Start Address" text boxes. Since the Router's default
IP
192.168.1.1, the Start
3. Enter the end of the
es in the "End
be entered here is 192.168.1.253.
4. Enter the subnet mask address in the "Subnet Mask" text boxes. The subnet
mask determines which portion of a destination
work portion, and which portion is the host portion.
5. If Windows Internet Naming Service (
server address in the "
Chapter 4 Using Network Connections
) is the method by which website or domain names
DNS
addresses. Specify such an address manually, according to
IP
.
ISP
server addresses, select Use the Following DNS
DNS
automatically assigns
DHCP
Address should be 192.168.1.2.
IP
address range used to automatically issue
IP
Address" text boxes. The "maximum"
IP
Server" text boxes.
WINS
server addresses, one pri-
DNS
addresses to the network
IP
LAN IP
) is being used, enter the
WINS
29
addresses to net-
IP
DHCP
server:
DHCP
address is
IP
address-
IP
address that can
IP
address is the net-
WINS