Mounting The Contivity 100 Unit On A Wood Wall; Preparing A Wood Wall For Mounting - Nortel Contivity 100 Setting Up

42 Chapter 2 Contivity 100 unit hardware installation

Mounting the Contivity 100 unit on a wood wall

To mount the Contivity 100 unit on a wood wall, you need a #6 wood screw (not
included) that is long enough to penetrate the wood by at least 1/2-inch.
Mounting the unit on a wood wall is a two-part process. You will:
1 Prepare the wood wall for mounting.
2
Mount the unit on the wall.

Preparing a wood wall for mounting

To prepare a wood wall for mounting, you will use a pencil to mark where the
brackets should be placed on the wall. Marking the wall makes mounting easier
because you limit the amount of time necessary to maneuver with the weight of
the unit in your hands and you ensure the accuracy of where the holes are placed.
To mark where the brackets should be placed on the wall:
1
Place your unit with attached brackets against the wall where you want to
mount the unit.
2
Use a pencil to mark where the holes should be placed in the wall for each
bracket.
After you mark the wall, you can mount the unit on the wall (next).
Mounting the Contivity 100 unit on a wood wall
You will attach one bracket at a time to the wall.
To mount the Contivity 100 unit on a prepared wood wall:
1
Align the holes in the attached bracket with the marks on the wall.
313369-A
Note: Before you mount the unit on a wall, you must attach the brackets
to the unit. See "Attaching the brackets to the Contivity 100 unit" on
page 39.