Nortel Contivity 100 Setting Up page 37

4
Attach the other end of the communications cable to the appropriate source
(phone jack, ISDN jack, cable modem, or other external device).
5
Do one of the following:
• To use the Contivity 100 unit as your LAN switch, attach up to seven
workstations to the seven-port switch (Eth1) on the front panel of the unit.
• To connect the Contivity 100 unit to your LAN, attach one end of the
LAN cable (straight-through or crossover) to one of the ports on the
seven-port switch (Eth1) and attach the other end of the cable to your
LAN.
6
Plug the power cord into the rear panel of the unit.
7
Plug the power cord into an AC wall outlet.
8
Turn on the unit.
When you turn on your Contivity 100 unit, LEDs 1 through 8 and the Power
LED illuminate. LED 2 glows amber when the unit is ready for configuration.
Note: You may have to wait several minutes for LED 2 to glow amber.
Note: If all LEDs glow amber, or none of the LEDs illuminates, check
that the power voltage selector switch setting matches your power
voltage. For more information, see
switch" on page
9
Configure the unit.
For information about configuring your unit, see Installing the Contivity Branch
Access Management Software Version 7.20.
Chapter 2 Contivity 100 unit hardware installation
"Setting the power voltage selector
34.
Setting Up the Contivity 100 Unit
37