Siemens SINUMERIK 802S Start-Up page 97

Number
36040 Delay zero-speed monitoring
(only
SPOS)
36050 Clamping tolerance
(only
SPOS)
36060 Maximum velocity/speed "axis/spindle stopped"
(only
SPOS)
36200 Threshold value for velocity monitoring (control parameter set no.): 0...5
36300 Encoder limit frequency
36302 Encoder limit frequency at which encoder is switched on again. (Hysteresis)
Zero mark monitoring (encoder no.):
0,1 0:
36310
1-99, >100: Number of recognized zero mark errors
100:
36610 Duration of the deceleration ramp for error states
36620 Cutout delay servo enable
36700 Automatic drift compensation
36710 Drift limit value for automatic drift compensation
36720 Drift basic value
SD for spindle
Number
43210 Progr. spindle speed limitation G25
43220 Progr. spindle speed limitation G26
43230 Spindle speed limitation with G96
Spindle MD parameterization
Spindle machine data are entered depending on the gear stages. Each gear stage is assigned
a parameter set.
The set of parameters selected corresponding to the current gear stage.
Example:
SINUMERIK 802S
6FC5 597–2AA00–0BP2 (01.02)
Explanation
Zero mark monitoring off, encoder
HW monitoring on
during monitoring
Zero mark monitoring off, encoder
HW monitoring off
Explanation
1st gear stage ! set of parameters [1]
Start-Up
4.7 Commissioning
Default
Value
0.4
0.5
0,0138
31,94
300000
99.9
0
0.05
0.1
0
1
0
Default
Value
0
1000
100
4-97