Siemens SINUMERIK 802S Start-Up page 59

Start–Up Switch Operator Panel
Start Up Menu
NCK start–up *
Normal power–up Normal power–up
Position 0
Power–up with Power–up with default
default values values
Position 1
Power–up with Power–up with saved
saved data data
Position 3
PLC Stop
after POWER ON
Position 4
PLC start up **
Restart
Restart
and debug mode
Restart with simulation
Overall reset
Overall reset and de-
bug mode
* Diagnosis/Start up / Start up switch / NCK softkey
The start–up switch PLC Stop can be activated either during operation or power–up.
The debug mode (see "Operation and Programming", Chapter 7) causes the PLC to remain in
PLC Stop after the control system has powered up. All power–up modes that have been set
either via softkeys or via hardware start–up switches will only come into effect after the next
power–up of the control system. The hardware start–up switch "PLC STOP" (position 4) is
active immediately. The priority of the power–up modes activated via the softkeys on the ope-
rator panel is higher than that of the hardware start–up switches.
Example:
S
Hardware start–up switch position 3
S
Restart from operator panel
=> Restart is active from next power–up of the control system
The Run mode activates the cyclic mode.
SINUMERIK 802S
6FC5 597–2AA00–0BP2 (01.02)
PLC Program Program
Selection Status
User program Run
User program Run
User program Run
Unchanged Stop
User program Run
User program Stop
Simulation pro- Run
gram
User program Run
User program Stop
** Diagnosis/Start up / Start up switch / PLC softkey
Start-Up
4.3 Starting up the PLC
Retentive Data MD for the
(Backed– PLC in the
Up) User Interface
Unchanged Accept active
PLC MD
Deleted Standard PLC
MD
Saved data Saved
PLC MD
Unchanged Accept active
PLC MD
Unchanged Accept active
PLC MD
Unchanged Accept active
PLC MD
Unchanged Accept active
PLC MD
Deleted Accept active
PLC MD
Deleted Accept active
PLC MD
4-59