Siemens SINUMERIK 802S Start-Up page 11

Software components
The SINUMERIK 802S comprises the following software components, which can be ordered:
S
System software on the permanent FLASH memory of the ENC
– Boot software,
loads the remaining system software from the permanent memory into the user me-
mory (DRAM) and starts the system.
– MMC software (Man Machine Communication),
implements all operating functions
– NCK software (NC Kernel)
implements all NC functions. This software controls an NC channel with a maximum of
3 movement axes and a spindle.
– PLC software (Programmable Logic Control),
executes the Integrated PLC user program cyclically.
– Integrated PLC user program
intended to adjust the SINUMERIK 802S to the machine functions (see also Descrip-
tion of Functions "Integrated User Program for SINUMERIK 802S").
S
Toolbox
– WinPCIN transfer program for a PC/PG (programming device) to transfer user data and
programs
– Text manager
– Cycle kit for loading into the control system using WinPCIN
– User program library
– Technological machine data files
– Programming tool
S
Update diskettes
– Update program with operator prompting system
– 802S system software, packed, for loading and programming the SINUMERIK 802S via
an update program.
User data
User data are:
S
Machine data
S
Setting data
S
Tool data
S
R parameters
S
Zero offsets
S
Compensation data
S
Part programs
S
Standard cycles
Data saving
After then, they might get lost.
SINUMERIK 802S
6FC5 597–2AA00–0BP2 (01.02)
Modified user data are saved for at least 50 h after power off or power failure.
SINUMERIK 802S Control System
1.1 Components of the SINUMERIK 802S
1-11