Siemens SINUMERIK 802S Start-Up page 146

Technical Appendix
6.3 PLC user program for turning (UPGMTURN)
Inputs
I0.0 Toolholder position: T1
I0.1 Toolholder position: T2
I0.2 Toolholder position: T3
I0.3 Toolholder position: T4
I0.4 Toolholder position: T5
I0.5 Toolholder position: T6
I0.6 Toolholder clamped
I0.7 Alarm input
I1.0 X+ limit switch
I1.1 Z+ limit switch
I1.2 X- limit switch
I1.3 Z- limit switch
I1.4 X reference point cam
I1.5 Z reference point cam
I1.6 Stepping drives ready
I1.7 EMERGENCY STOP
MSTT Customer keys
User K1: Reduce spindle speed <<
User K2: Spindle jogging
User K3: Increase spindle speed >>
User K4: Manual tool change
User K5: Start manual lubrication
User K6: Cooling ON/OFF (toggle switch)
User K7:
User K8: not assigned
User K9: not assigned
User K10: not assigned
Outputs
O0.0 Spindle start CW (direction of rotation M3)
O0.1 Spindle start CCW (direction of rotation M4)
O0.2 Spindle stop with brake
O0.3 Coolant control
O0.4 Toolholder motor CW (forward)
O0.5 Toolholder motor CCW (reverse)
O0.6 Lubricant control
O0.7 Alarm output
O1.0 Spindle speed stage1
O1.1 Spindle speed stage2
O1.2 Spindle speed stage3
O1.3 Spindle speed stage4
O1.4 Spindle speed 1 (for display)
O1.5 Spindle speed 2 (for display)
O1.6 Spindle speed 3 (for display)
O1.7 Spindle speed 4 (for display)
6-146
Signal Description
Reset alarm output
X2003
X2004
X2005
X2006
M41 M42 M43
n n
n
n n
n
6FC5 597–2AA00–0BP2 (01.02)
M44
n
n
SINUMERIK 802S