Replacing A Pci Adapter - IBM ThinkCentre 8105 Hardware Replacement Manual

5. Position the replacement memory module over the memory connector. Make
6. Go to "Completing the parts replacement" on page 26.

Replacing a PCI adapter

This section provides instructions on how to replace a PCI adapter.
22
Hardware Replacement Guide
sure that the notch 1 on the memory module aligns correctly with the
connector key 2 on the system board. Push the memory module straight
down into the memory connector until the retaining clips close.
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Quick Reference that was included with your computer or in the
Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Quick
Reference or HMM, go to http://www.ibm.com/pc/support/.
1. Open the computer cover. See "Opening the cover" on page 5.
2. Pivot the drive bay assembly upward to gain access to the system board.
3. Locate the cable clip. See "Locating components" on page 3.
4. Remove all cables from the cable clip attached to the PCI riser.