Table of Contents
Advertisement
Important
Do not touch the gold contacts on the bottom of the microprocessor. If
you must touch the microprocessor, touch only the sides.
a. Take notice of the orientation of the notches 1 on the microprocessor.
This is important when reinstalling the microprocessor on the system
board.
b. Do not drop anything on the socket while it is open. Keep all contacts as
clean as possible.
8. Make sure that the lever on the microprocessor retainer is fully open.
9. Loosen the black cover 3 that protects the gold contacts on the
microprocessor 2 , but do not remove it. Use the vacuum pen 1 to pick up
the new microprocessor then completely remove the black cover. Place the
black cover on the old microprocessor.
Chapter 2. Replacing hardware
15
Hide quick links:
Advertisement
Table of Contents
