Step 7: Test And Troubleshoot - Extron electronics EBP 108 RAAP Button Panel Setup Manual

Step 6: Configure or Program the System
EBPs are shipped with pre-labelled buttons in place but these buttons do not have any functions associated with them until
they are configured with Global Configurator or programmed with Global Scripter. See the Global Configurator Help File or the
Global Scripter Help File for step-by-step instructions and detailed information.

Step 7: Test and Troubleshoot

Verify that the DIP switches on the EBPs are set to the desired address on each device and that there are no BUS ID conflicts
1.
in the system (see Step 4: Set BUS ID Addresses
The eBUS status LEDs (see
2.
ID address conflicts.
The EBP 108 RAAP has three LEDs:
Off — If all three LEDs are off, the device is not receiving power.
•
Yellow LED— Lights steadily when the device is receiving power but communication with the control processor is not
•
confirmed.
Red LED— Lights steadily when there is a BUS ID address conflict.
•
Green LED — Lights steadily when power and communication are both confirmed.
•
Verify that cables to and from the EBPs are wired in the same way at each end (pin 1 to pin 1, pin 2 to pin 2, and so forth).
3.
Test the system.
4.
Press buttons on the EBPs and ensure that the buttons light as desired and that the appropriate control commands or
•
functions are triggered.
Ensure that the audio output responds correctly to the volume knob or button. Also ensure that the volume LEDs light
•
correctly as you increase or decrease the audio gain.
Make adjustments to wiring, BUS ID address, or system configuration as needed. Remember that the rear panel ports and
5.
DIP switches are not accessible after the EBP is mounted. If needed, upload a revised configuration to the control processor.
If you have questions during installation and setup, contact the
Systems Support Hotline (1.800.633.9877).
on page 4).
figure 1, A , on page 1) provide information about power and communication status and bus
Extron S3 Sales & Technical Support
Product Category
or the Extron S3 Control
9