Table of Contents
Advertisement
EBP 108 RAAP Button Panel • Setup Guide (Continued)
To reset the firmware
Disconnect the eBUS cable that is providing power.
1.
Press and hold down the
2.
Reset
Release the
3.
When the eBUS Connection Status LED lights, the reset process is complete.
NOTES:
•
If the reset is carried out while the EBP is receiving power from a 12 VDC power supply, the firmware is reset to the
factory default.
•
If the reset is carried out while the EBP is receiving power from a control processor, the firmware is reset to the factory
default but the control processor may then push a more recent version of the firmware to the EBP.
Front Panel Features
A A
ON
OFF
D D
EBP 108 RAAP Front Panel
EBP 108 RAAP Front Panel
Figure 2.
The buttons and encoders must be configured or programmed to carry out their functions.
A
Power Buttons — These two buttons control the power to a display
B
Function Buttons — These six buttons can be set up to carry out a variety of functions, either by configuration with Global
Configurator Plus and Professional, or programming with Global Scripter, (see the software help file for more information).
C
Volume Control LEDs and Rotary Encoder — Use the encoder to adjust the volume level. The LEDs provide a visual
representation of the volume level.
D
Front Panel Screws — These four Phillips-head screws hold the faceplate to the unit.
Planning the System and Installation
When planning to install an eBUS system you must consider how many EBP button panels to use, maximum cable distance,
cabling topology, and mounting. See the eBUS Technology Reference Guide for more information about eBUS topologies.
Installation
Step 1: Get Ready
Use the following checklist to prepare for the installation.
…
Download and install the latest version of the software, firmware, and device drivers needed to configure the IPCP Pro control
processor and control the connected AV products. See the IPCP Pro Series User Guide (available at www.extron.com) for
details on software and drivers.
…
Obtain network information (IP addresses, passwords, DHCP settings, and so on) and the MAC address for the control
processor.
…
Obtain model names, drivers, and setup information for AV devices.
…
Determine which eBUS cabling topologies to use and obtain cables, mounting hardware, and any power supplies or hubs
required by that configuration (see the eBUS Technology Reference Guide for more information about eBUS topologies).
2
Reset
button and, while holding down the
button 1 second after reconnecting power. During the reset process, the front panel buttons are not lit.
B B
DOC
PC
LAPTOP
VGA
HDMI
CAM
EBP 108 RAAP
D D
Reset
button, reconnect eBUS cable.
C C
MUTE
D D
Advertisement
Table of Contents
