Removal; Installation; Cowl Cover; Exterior Name Plates - Chrysler Sebring 2005 Service Manual

23 - 60 EXTERIOR

COWL COVER

REMOVAL

(1) Release hood latch and open hood.
(2) Remove windshield wiper arms (Refer to 8 -
ELECTRICAL/WIPERS/WASHERS/WIPER ARMS -
REMOVAL).
(3) Remove screws attaching cowl cover to cowl
(Fig. 4).
(4) Remove the seal, cowl screen to hood inner
panel.
(5) Remove clips attaching cowl cover to cowl ple-
num under hood to cowl bulb seal.
(6) Remove cowl cover from vehicle.
Fig. 4 Cowl Cover
1 - SEAL
2 - COWL
3 - COWL COVER

INSTALLATION

(1) Position cowl cover to vehicle.
(2) Install clips attaching cowl cover to cowl ple-
num.
(3) Install the seal, cowl screen to hood inner
panel.
(4) Install screws attaching cowl cover to cowl.
(5) Install windshield wiper arms (Refer to 8 -
ELECTRICAL/WIPERS/WASHERS/WIPER ARMS -
INSTALLATION).

EXTERIOR NAME PLATES

REMOVAL - FOAM TAPE

(1) Mark reference points before removing.
(2) Using a heat gun gently apply heat in a circu-
lar motion to loosen the adhesive bond.
(3) Using a trim stick C 4755 or equivalent, gently
pry up at corners and remove.
(4) Clean off all traces of adhesive or double sided
tape from the panel with a general purpose adhesive
remover.

INSTALLATION - FOAM TAPE

(1) Clean panel surface with isopropyl alcohol.
(2) Align badging to reference points.
(3) Install and press securely to full adhesive con-
tact
(4) Clean away any reference points.
JR