Removal; Installation; Front Door Inner Belt Weatherstrip; Front Door Outer Belt Molding - Chrysler Sebring 2005 Service Manual

JR
FRONT DOOR GLASS RUN WEATHERSTRIP (Continued)
(4) Install door glass. (Refer to 23 - BODY/DOOR -
FRONT/DOOR GLASS - INSTALLATION)
FRONT DOOR INNER BELT
WEATHERSTRIP

REMOVAL

(1) Remove front door trim panel. (Refer to 23 -
BODY/DOOR - FRONT/TRIM PANEL - REMOVAL)
(2) Pull upward at rear end of inner belt weather-
strip.
(3) Remove inner belt weatherstrip from vehicle
(Fig. 9).
Fig. 9 Front Door Inner Belt Weatherstrip
1 - FRONT DOOR
2 - INNER BELT WEATHERSTRIP

INSTALLATION

(1) Place inner belt weatherstrip into position.
(2) Start weatherstrip at the front and rear edge
door. Press downward on the inner belt weatherstrip
till it is fully seated.
(3) Install front door trim panel. (Refer to 23 -
BODY/DOOR - FRONT/TRIM PANEL - INSTALLA-
TION)
FRONT DOOR OUTER BELT
MOLDING
REMOVAL
(1) Remove screw attaching rearward end of mold-
ing to front door (Fig. 10).
(2) Using a rubber mallet and block of wood, tap
upward at each clip attaching belt molding to door
(Fig. 11).
(3) Lift up on the rear of the belt molding and pull
rearward to remove.
WEATHERSTRIP/SEALS
Fig. 10 Front Door Outer Belt Molding
1 - OUTSIDE BELT MOLDING
2 - FRONT DOOR
Fig. 11 Front Door Outer Belt Molding Removal
1 - WOOD BLOCK
2 - BELT MOLDING
3 - DOOR
INSTALLATION
(1) Place belt molding in position.
(2) Using your hand press downward at each clip
attaching belt molding to door till in position.
(3) Install screw attaching rearward end of mold-
ing to front door.
HEADER / A-PILLAR
WEATHERSTRIP
REMOVAL
(1) Partially raise convertible top.
(2) Remove inside rear view mirror.
(3) Remove sun visors.
(4) Remove header trim panel.
23 - 143