Kia Sorento 2001 General Information Manual page 1169

2001 > 1.8L DOHC >
Circuit operation
Turn lights
With the ignition switch in "ON" or "START", battery voltage is applied from "TURN(10A)" fuse to the flasher
unit through the hazard switch (Hazard switch is OFF). When the turn signal switch is turned to "LH" or "RH"
position, the flasher unit alternately opens and closes a solid state switch, which send pulses of battery voltage
to the "LH" or "RH" turn lights, side lights and indicator through turn switch. The appropriate lights and indicator
flash.
Harzard lights
Battery voltage is always applied from "HAZARD" fuse to the flasher unit through the R/W wire. The flasher unit
is grounded through B wire permanently. When the hazard switch is pressed battery voltage is applied to the
flasher unit through the hazard switch. The flasher until alternately opens and closes to a soild state switch
which sends pulses of battery voltage is applied to the turn lights, side lights and indicators through the hazard
switch. The lights and both indicators flash "ON" and "OFF" until the hazard switch open.