Table of Contents
Advertisement
All manuals and user guides at all-guides.com
4. Selec t your new print server from the displayed list and press Enter. The
name listed will be the same as the Device Name printed on a label on your
print server.
5. A list of defaults will be displayed.
If you need to change any of these
items, use the arrow keys to choos e the item you need to change, then press
Enter to display a list of choices. When all of the values are correc t, select
the Continue Installation item and press Enter.
6. The quick installation program will not only set up the print server, but
create and s etup all required objec ts on the file server. When the setup is
complete, it will also display an execution command as following that you can
run after logging in to the file server to redirec t print commands to the new
print server. :
capture /S= III /Q= PRINTSERVER_Q1 /nt /nff /nb /l=1 /ti=10
This redirects the LPT1 port (/l=1) to the print queue PRINTSERVER_Q1 on
the file server named III. No banner page will be printed (/nb), no form feed
will be added to the end of the job (/nff), and tabs will not be expanded into
43
Advertisement
Table of Contents
