Lock Set Up Group; Table 17 Lock Set Up Group Parameters - Honeywell HercuLine 10260S Installation, Operation And Maintenance Manual

Lower Display
Prompt
UNITS

Lock Set Up Group

Table 17 lists the parameters and selections available for the SET LOCK group.
Lower Display
Prompt
LOCKID
LOCK
MAENAB
Revision 5 10260S HercuLine® Actuator Installation, Operation and Maintenance Manual
7/07
Upper Display
Selections or
Range of Setting
DISPLAY UNITS—Selects standard for unit values for the
local display.
SI SI—Display will show unit values in international (metric)
units. (Temperature in degrees C, Date format: ddmmyy)
ENGL English—Display will show unit values in U.S. units.
(Temperature in degrees F, Date format: mmddyy)

Table 17 Lock Set Up Group Parameters

Upper Display
Selections or
Range of Setting
Nnnn PASSWORD LOCK—4-digit password can be selected to
n = 1 to 9 provide security access to calibration information, set up
parameters and supervisory functions. Password can be a
(Up a limit of 4095)
number from 0 to 4095.
A password is required in order to change the lock
parameter.
See "Set/Change Password" below.
LOCK OUT FEATURE—Selects lockout security for
calibration and supervisory functions, and set up groups.
NONE None—No lockout of any calibration or set up groups. You
[default] select and change set up group values, and perform field
calibration.
CAL Calibration—Lockout for calibration groups SET CALIN,
SET CALMTR, SET CALOUT and CAL NCSOUT only. You
can select and change set up group values.
CONF Configuration—Lockout for calibration groups and set up
group configuration. You can only scroll through and view
set up group values.
FULL Full—Lockout for calibration and all set up group values.
Only SET LOCK and READ STATUS groups are accessible.
DIS AUTO / MANUAL MODE LOCKOUT --
[default] DIS—disables the mode key on the keypad.
ENAB ENAB—enables the mode key on the keypad.
4. Set Up and Calibration Procedures - Lock Set Up Group
Parameter Definition
Parameter Definition
47