Figure 9 Turnbuckle Linkage Kit; Figure 10 Pipe Leakage Kit - Honeywell HercuLine 10260S Installation, Operation And Maintenance Manual

Smart actuator

Table of Contents

Turnbuckle Linkage Kits

Turnbuckle linkage kits are available from Honeywell and are used where short lengths are required. The

lengths range from 12 to 24 inches and refer to the rod end center-to-center distance. These kits include the

turnbuckle, load rod end (left-hand thread), connecting rods and locking nuts. See Figure 9. The actuator

rod end (right-hand thread), nut and bolt are supplied with the actuator. The nut and bolt needed to connect

the rod end to the load are supplied by the customer. Kits can be ordered with the Actuator via Table VI of

the Model Selection Guide or separately as identified in section 8 of this manual.

Rod end, nut and bolt are

supplied with the actuator

Pipe Linkage Kits

Pipe linkage kits are available from Honeywell and can be used for linkage lengths from 24 to 120 inches

(60 to 305 cm). The kits include the mechanical pipe couplings, load rod end (left-hand thread), connecting

rods and locking nuts. See Figure 10 Pipe Leakage Kit

. The actuator rod end (right-hand thread), nut and bolt are supplied with the actuator. The customer must

supply a piece of schedule 40 pipe * (both ends with right-hand NP threads) and a nut and bolt to connect

the rod end to the load. Pipe linkage kits can be ordered with the Actuator using Table VI of the Model

Selection Guide or separately as identified in Section 8 in this manual.

Rod end, nut and bolt are

supplied with the actuator

1/2"-20 right-hand threads

*Pipe length = Overall linkage length minus (-) 17 inches (43 cm).

Revision 5

10260S HercuLine® Actuator Installation, Operation and Maintenance Manual

7/07

(See Section 8 for available Kit numbers)

1/2"-20 right-hand threads