Phones; Total - Boss GT-1000 Parameter Manual

GLOBAL EQ
This adjusts the tone of the OUTPUT regardless of the equalizer on/off
settings of individual patches.
* If the STEREO LINK is ON, the L settings are also applied to R.
Parameter Value
STEREO LINK OFF, ON
L LOW GAIN
-20–+20dB
R LOW GAIN
L MID GAIN
-20–+20dB
R MID GAIN
L MID FREQ
20.0Hz–16.0kHz
R MID FREQ
L MID Q
0.5–16
R MID Q
L HIGH GAIN
-20–+20dB
R HIGH GAIN
L LOW CUT FLAT,
R LOW CUT 20.0Hz–20.0kHz
L HIGH CUT 20.0Hz–20.0kHz
R HIGH CUT FLAT
LEVEL -20–+20dB
OUTPUT LEVEL
Parameter Value
LEVEL SELECT -10dBu, +4dBu
OUTPUT LEVEL 0–100
Explanation
If this is ON, the L and R settings are made
at the same time.
Adjusts the tone for the low frequency
range.
Adjusts the tone for the middle frequency
range.
Specifies the center of the frequency
range that will be adjusted by the MID
GAIN.
Adjusts the width of the area affected by
the EQ centered at the MID FREQ. Higher
values will narrow the area.
Adjusts the tone for the high frequency
range.
This sets the frequency at which the low
cut filter begins to take effect. When FLAT
is selected, the low cut filter will have no
effect.
This sets the frequency at which the high
cut filter begins to take effect. When FLAT
is selected, the high cut filter will have no
effect.
Adjusts the output level.
Explanation
Specifies the output reference level as
appropriate for the input level of the device
connected to the OUTPUT jacks.
Adjusts the output level (SUB OUT only).

PHONES

This specifies the signal that is output from the PHONES jack.
Parameter Value Explanation
MAIN OUT The MAIN OUT signal is output to headphones.
PHONES SUB OUT The SUB OUT signal is output to headphones.
SETTING
The MAIN OUT and SUB OUT signals are mixed
MAIN+SUB
and output to headphones.

TOTAL

These parameters control the threshold level of the noise suppressor
used by each patch, the overall reverb level, and the overall output.
They do not affect the settings of each patch.
Parameter Value
-20dB–0dB–
NS THRESHOLD
+20dB
REVERB LEVEL
0%–200%
Specifies the metronome's output destination.
MAIN OUT
METRONOME
SUB OUT
OUT
MAIN+SUB
MENU
Explanation
Control the threshold level of the noise
suppressor used by each patch.
It is effective to adjust this when you
switch to connecting a different guitar, or
according to the amount of noise in the
performance venue. This does not affect the
settings of each patch.
* If you want to use the settings specified
for each patch, set this to 0 dB.
Adjusts the reverb level specified for each
patch.
It is useful to adjust the reverb level
appropriately for the space in which you're
performing. This does not affect the settings
of each patch.
* If you want to use the settings specified
for each patch, set this to 100%.
Output from MAIN OUTPUT.
Output from SUB OUTPUT.
Output from both MAIN OUTPUT and SUB
OUTPUT.
39