Mitsubishi FX3U-20SSC-H Quick Start Manual page 15

Servo /// Motion ///
Follow the steps below to activate the absolute position detection system.
1) Set the servo parameters
Double click on 'Servo parameters' in the 'File data list' panel on the left-hand
side to modify the servo parameters. Be sure to change settings for BOTH the X &
Y axes.
Set the necessary items from the 'Kind' column:
· Basic setting parameters → Absolute position detection system → Selection of
absolute position detection system →
Set all other parameters that are needed for your system if necessary.
2) Write the servo parameters
Write
the 'Write to module' button or by using [Online → Write to module (Ctrl+T).]
Select only the servo parameters and put a check mark in the 'Flash ROM write'
box as shown below. Click the OK button and proceed with selecting 'Yes' and
then 'OK.'
Mitsubishi Electric Europe B.V. /// FA-European Business Group /// Gothaer Strasse 8 /// D-40880 Ratingen /// Germany
Tel: (02102) 4860 /// Fax: (02102) 486112 /// Email:info@mitsubishi-automation.com /// Web: www.mitsubishi-automation.com
Servo /// Motion ///
"1: Used in absolute position detection system"
the servo parameters to the 20SSC-H BFM and Flash ROM by pressing
Servo /// Motion ///
Only the Servo parameters
are selected to be written
Check 'Flash ROM write' so
that these settings are active
every time the power is
turned ON.
Servo /// Motion ///
for X- and Y-axes.
.
Servo