For The Operator; How To Set The Machine Head And To Initialize Data (The Factory-Set State At The Time Of Shipment) - JUKI DDL-8000A Instruction Manual

4. FOR THE OPERATOR

4-1. How to set the machine head and to initialize data (the factory-set state at the time of
shipment)
* This item has been factory-adjusted at the time of shipment. Carry out the machine head setting procedure
in the case the control box is replaced, or in any case where it is necessary.
A
❼ to flash the set value (B) on and off. In this state, select the corresponding type of
2) Press
machine head by pressing
Set value = 2: DDL8000APMS
Set value = 3: DDL8000APSH
3) Data is initialized by pressing
* If you want to initialize the data, change the setting of the type of machine head to a different type, then
select the desired type of machine head.
Example) In the case the selected type of machine head is "2":
P70 Change the selected type of machine head from "2" to "3". Press
Change the selected type of machine head again from "3" to "2". Press
❻ ❼
B
❻ .
❽ . Then, the sewing machine returns to the normal sewing state.
– 22 –
1) Refer to "4-6. Function setting" p.
31
and call the function setting No.
P70 (A).
❽
❽ .
❽ .