Installing Software; Labview Installation; Labview Real-Time Module Installation - National Instruments PXI-7830R Getting Started

The PCI-7831R supports NI-RIO 1.1 or later.
Note
RTX 5.5 does not support Hyper-Threading enabled processors. Refer to the RTX
Note
documentation for information about disabling multiprocessor access.

Installing Software

LabVIEW Installation

LabVIEW Real-Time Module Installation

Note If you are using the NI 783xR with Windows 2000/XP only, it is not necessary to
install the LabVIEW Real-Time Module.
Getting Started with the NI 783xR
❑
Computer running Windows 2000/XP and RTX.
❑
At least one cable and device for connecting signals to the PCI-783xR.
Complete the following sets of steps in the order listed to successfully
install LabVIEW, the LabVIEW Real-Time Module, the LabVIEW FPGA
Module, and the NI-RIO device drivers.
If you are using NI-RIO without LabVIEW, skip these steps and proceed to
the NI-RIO Device Drivers Installation
Complete the following steps to install LabVIEW. Refer to the LabVIEW
Release Notes for additional information about installing LabVIEW.
1. Insert the LabVIEW CD into the CD-ROM drive to display the
LabVIEW installation screen.
2. Click Install LabVIEW.
3. Follow the installer prompts through the rest of the installation.
Complete the following steps to install the LabVIEW Real-Time Module.
Refer to the LabVIEW Real-Time Module Release Notes for additional
information about installing the LabVIEW Real-Time Module.
1. Insert the LabVIEW Real-Time Module CD into the CD-ROM drive
to display the LabVIEW Real-Time Module installation screen.
2. Click Install LabVIEW Real-Time Module.
3. Follow the installer prompts through the rest of the installation.
section.
6 ni.com