Labview Fpga Module Installation; Ni-Rio Device Drivers Installation - National Instruments PXI-7830R Getting Started

LabVIEW FPGA Module Installation

NI-RIO Device Drivers Installation

Note You must install LabVIEW and the LabVIEW modules you will use before you
install the NI-RIO device drivers.
© National Instruments Corporation
Complete the following steps to install the LabVIEW FPGA Module. Refer
to the LabVIEW FPGA Module Release Notes for additional information
about installing the LabVIEW FPGA Module.
1. Insert the LabVIEW FPGA Module CD into the CD-ROM drive to
display the LabVIEW FPGA Module installation screen.
2. Click Install LabVIEW FPGA Module.
3. Follow the installer prompts through the rest of the installation.
Complete the following steps to install the NI-RIO device drivers that are
included with the NI 783xR device.
1. Run
setup.exe
instructions.
2. Follow the on-screen instructions until the Feature Tree window
appears.
3. In the Feature Tree window, select the components to install. You must
install NI-VISA, NI-RIO, and NI Measurement & Automation
Explorer (MAX).
4. Follow the on-screen instructions to complete the driver installation.
5. Restart the computer.
from the NI-RIO CD and follow the setup
7 Getting Started with the NI 783xR