National Instruments PXI-7830R Getting Started page 4

Note The PXI-7831R supports NI-RIO 1.1 or later.
Note The PCI-7831R supports NI-RIO 1.1 or later.
Getting Started with the NI 783xR
– LabVIEW Real-Time Module 7.1 or later.
– NI-RIO 1.3 or later—included with the PXI-783xR.
– Ardence (formerly Venturcom) RTX 5.5 or later.
❑
PXI/CompactPCI chassis and real-time embedded controller running
Windows 2000/XP and RTX.
❑
CAT 5 Ethernet crossover cable if the real-time PXI system is not
configured on a network. To connect the PXI system to a network port,
use a standard CAT 5 10/100Base-T Ethernet cable.
❑
At least one cable and device for connecting signals to the PXI-783xR.
PCI-783x R with Windows 2000/XP
The following items are necessary to set up and use the PCI-783xR on a
computer running Windows 2000/XP:
❑
PCI-783xR.
❑
The following software packages:
– LabVIEW 7.1 or later.
– LabVIEW FPGA Module 1.1 or later—required to develop
custom FPGA VIs.
– NI-RIO 1.3 or later—included with the PCI-783xR.
❑
Development computer running Windows 2000/XP.
❑
At least one cable and device for connecting signals to the PCI-783xR.
4 ni.com