Vfpc28In Log Placement - Empire Comfort Systems VFPC20in33N-1 Installation Instructions And Owner's Manual

Before you begin: Do not, handle these logs with your bare hands!
Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation
of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
Failure to position the parts in accordance with this diagram
or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
PROPER INSTALLATION SEQUENCE:
(Figure 25)
1. Place rear log (#1) onto two (2) pins on rear log support.
2. Place left, front log (#2) onto two (2) left, front pins on burner pan.
3. Place right, front log (#3) onto two (2) right, front pins on burner pan.
4. Place Y Branch (#4) onto two (2) pins on rear log.
5. Compare the completed log installation with the photo on page
26. Review previous steps to make any necessary adjustments.
6. Log placement is completed.
Attention: Do not use Figure 25 to order replacement logs. Refer
to the Parts List and Parts View to order logs.
Rock wool can be added to burners for a glowing ember effect.
Apply loose material (glowing embers) only on locations shown on
Page 26. Replacement of loose material (glowing embers) must be
purchased from Empire Comfort Systems, Inc. Application of excess
loose material (glowing embers) may adversely affect performance
of the heater.
All previously applied loose material must be removed prior
to reapplication.
8. Install front frame assembly.
39236-1-0219

VFPC28IN LOG PLACEMENT

WARNING
WARNING
replacement Loose Material (glowing embers) Part
Number: 15999
NOTICE: A single layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with production
embers) to the burner.
1
2
Log Placement
The following WARNING applies when log set is installed onto an
unvented gas burner assembly.
This appliance is equipped for (natural or Propane Gas).
Field conversion is not permitted.
4
3
Figure 25
WARNING
Page 25