Table of Contents
Advertisement
ASSEMBLY
SANDING BELT TABLE
1. Slide the belt into the slot on the
table.
2. Position the table so that the
machined slot below lines up with
the hole in the casting.
3. Use the handle and washer
supplied to fix the table into
position.
NOTE: The distance between the
belt and the table must be
no more than 1.5mm (1/16")
to prevent small pieces
slipping down between the
belt and table.
DUST EXTRACTION MOULDING
1. Use a suitable screwdriver to
remove the 3 screws and washers.
2. Place the dust extraction
moulding into position.
3. Use the screws you removed in
step 1 to fix into place.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
6
Advertisement
Table of Contents
