Sanding Small End Surfaces On The Sanding Disc - Clarke Woodworker CS4-6C Operation & Maintenance Instructions Manual

Always sand outside curves on the left
side of centre on the sanding disc as
shown.
WARNING: Applying the workpiece to
the right side of the disc could cause
workpiece to fly up (kick-back) and
result In an Injury.

Sanding Small End Surfaces On The Sanding Disc

NOTE: Use of a Mitre Gauge is
recommended for this operation.
Always move the work across left side of
centre on the sanding disc face as
shown.
The table may be tilted for bevelled
work.
Always position the workpiece to the left
of centre on sanding disc with disc
rotating anticlockwise as shown.
WARNING: Applying the workpiece
to the right side of the disc first could
cause workpiece to fly up (kickback)
and result in an Injury.
WARNING: For your own safety,
turn switch "OFF" and remove plug
from power source outlet before
adjusting your sander.
NOTE: Use a combination square
to square the mitre gauge to the
face of the disc (combination
square must be "true" - See
"Unpacking - Tools Required"
section on page 8 for checking
this method). If it is not square,
loosen the mitre gauge knob and
move the mitre gauge slightly
until it is square. Without moving
the mitre gauge, tighten the knob
securely.
17