Charging The Battery Pack - Sony Handycam DCR-PC101 Operating Instructions Manual

Step 1 Preparing the power supply

Charging the battery pack

Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the "InfoLITHIUM" battery pack (M series).
See page 205 for details of the "InfoLITHIUM" battery pack.
(1) Install the battery pack on your camcorder.
(2) Open the jack cover and connect the AC power adaptor supplied with your
camcorder to the DC IN jack with the plug's v mark facing the Holding Grip.
(3) Connect the power cord to the AC power adaptor.
(4) Connect the power cord to a wall outlet.
(5) Set the POWER switch to OFF (CHARGE).
The CHARGE lamp lights up when the charge begins. After the charge is
completed, the CHARGE lamp goes off (full charge).
3
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camcorder.
While charging the battery pack, the CHARGE lamp flashes in the following cases:
– The battery pack is not installed correctly.
– Something is wrong with the battery pack.
When you use the AC power adaptor
Place the AC power adaptor near a wall outlet. If any trouble occurs with this unit,
disconnect the plug from a wall outlet as soon as possible to cut off the power.
CHARGE lamp
2
5
POWER LOCK
15