Recording An Image From A Tape As A Still Image - Sony Handycam DCR-PC101 Operating Instructions Manual

Recording an image from a tape as a still image

Your camcorder can read moving picture data recorded on a tape and record it as a still
image on a "Memory Stick."
Your camcorder can also take in moving picture data through the input connector and
record it as a still image on a "Memory Stick."
Before operation
•Insert a recorded tape into your camcorder.
•Insert a "Memory Stick" into your camcorder.
(1) Set the POWER switch to VCR.
(2) Press
(3) Keep pressing PHOTO lightly until the picture from the tape freezes.
CAPTURE appears on the screen. Recording does not start yet.
To change the still image, release PHOTO, select a still image again, and then
press and hold PHOTO lightly.
(4) Press PHOTO deeper. Recording is complete when the bar scroll indicator
disappears. The image displayed on the screen when you pressed PHOTO
deeper will be recorded on the "Memory Stick."
2
Image size of still images
Image size is automatically set to 640
When the access lamp is lit or flashing
Do not shake or strike the unit. As well do not turn the power off, eject a "Memory
Stick" or remove the battery pack. Otherwise, the image data breakdown may occur.
If " " appears on the screen
The inserted "Memory Stick" is incompatible with your camcorder because its format
does not conform with your camcorder. Check the format of the "Memory Stick."
. The picture recorded on the tape is played back.
3
4
480.
SFN
1 / 12
640
CAPTURE
FN
SFN
640
FN
127