Conversion From Ng To Lpg - Regency F38NG2-BRA Owners & Installation Manual

INSTALLATION
CONVERSION KIT# 731-968 FROM NG TO LPG
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
LPG Conversion Kit Contains:
Qty. Part # Description
1 910-037 LPG Injector
(Pilot Orifice)
1 904-390 Burner Orifice #52
1 908-528 Red "LPG" label
1 908-255 Label "Converted to
LPG"
1 904-529 5/32" Allen Key
1) Shut off the gas supply.
2) Open the front door and carefully remove
the logs and lava rock.
3) Remove burner. See diagram below.
Note: Use a magnetic type screwdriver
if possible.
Pilot assembly is now accessible
for steps 4) to 9).
4) Open pedestal door and remove the gold
chain from door which will allow door to
fall.
5) Remove lighting panel by removing the 6
Phillips head screws and put to the side.
6) Remove hi-low extension knob.
7) Turn control knob to
the "OFF" position.
8) Remove the black
protection cap by
hand from the high-
low knob (Fig.1).
Fig. 1
8
9) Insert a 5/32" or
4mm Allen wrench
into the hexagonal
key-way of the
screw (Fig. 2), rotate
it counter-clockwise
until it is free and
extract it.
Fig.3
10) Check that the screw is clean and if
necessary remove dirt.
11) Flip the screw (Fig. 3).
12) Using the Allen
wrench as shown
in Fig.4, rotate the
screw clockwise
until snug, do not
overtighten.
Fig.2
Fig.4
WARNING!
Do not over tighten the screw.
Recommended to grip the
wrench by the short side.
13) Verify that if the conversion is from NG to
LPG, the screw must be re-assembled
with the red o-ring visible (Fig. 5).
LPG Configuration
Red o-ring visible
Fig.5
14) Re-assemble the
black protection
cap (Fig. 6).
Fig. 6
WARNING!
Also check that the pilot
and main burner injectors are
appropriate for the gas type.
15) Pull off the pilot cap to expose the pilot
orifice.
16) Unscrew the pilot orifice with the allen
key and replace with the LPG pilot orifice
in the kit.
17) Remove burner orifice with a 1/2" wrench
while using a 9/16" wrench to hold onto
the elbow behind the orifice, then discard
the orifice.
Burner Orifice
18) Reinstall new burner orifice LPG stamped
#52 and tighten.
19) Reverse steps 3) to 2).
20) Attach the label "This unit has been con-
verted to LPG" near or on top of the Serial
# decal.
21) Replace yellow "NG" label with red "LPG"
label.
Regency F38-2 Freestanding Gas Stove