Table of Contents
Advertisement
Adjustable Gun Arm Installation
(24G628, 24G629)
1. Position the gun arm next to the vehicle.
2. Pull the gun arm beam out to the side of the vehicle
where the gun arm is located. Lift the gun arm and
hold the traverse bracket in the position shown
below. Slide the beam through the wheels so they
are mounted on the track of the gun arm beam as
shown below.
ti18143a
3. Attach the handle (704) to each end of the gun arm
beam. Press the cotter pin (707) through the handle
to hold it in place. Fasten nut (706) and bolt (705)
through the slide beam on both ends to act as stops
on the channel.
708
707
ti16662a
3A2091B
704
706
705
Install Safety Switch and Gun
Arm Stow Plate
1. Remove two nuts and washers from safety switch
bracket and remove from gun arm.
2. Disconnect two wires on safety switch and pull wires
out of rectangular tube.
ti18147a
3. Reposition and install safety switch bracket as
shown.
4. Install gun arm stow plate as shown.
Setup
ti18147a
ti18147a
ti18150a
ti18147a
17
Advertisement
Table of Contents
