Emergency Shut Off; Load Reflecting Materials; Set Up Adjustable Gun Arm Beam And Gun Arm - Graco RoadLazer RoadPak 24M143 Operation Manual

Emergency Shut Off

To shut down the entire Tow-Behind system, set
POWER ON/OFF on the Programmable Skipline Con-
troller to the OFF position.

Load Reflecting Materials

1. Set POWER ON/OFF on Programmable Skipline
Controller to OFF.
2. Set RoadPak engine ignition key to OFF.
3. Relieve air system pressure by opening ball valve
until gauge reads 0.
4. Relieve air pressure in bead tank by turning bead
system valve to OFF position.
5. Remove cover from bead tank.
6. Screen reflective materials to prevent debris from
entering tank.
7. Load bead tank with reflective materials.
3A2091B
Set Up Adjustable Gun Arm
Beam and Gun Arm
1. Unlock gun arm clamp and gun arm beam clamps.
2. Pull gun arm beam to left or right side of vehicle.
Lock slide beam clamps.
3. Remove gun arm from upright stowed position, and
slide to end of gun arm beam. Slowly lower gun
arm, and lock into position with clamp.
Operation
ti16425a
ti16423a
25