Soldering Jumpers On The Interface Board - Samson Trovis 6400 Mounting And Operating Instructions

Soldering jumpers on the interface board

4.4. Soldering jumpers on the interface board
See. Fig. 5 for the location of the interface board and Fig. 6 for the location of the soldering
jumpers.
Important! In the interface mode, the soldering jumpers LB1, LB2 and LB3 on the logic board
must also be closed (see section 4.2., page 19). This must be observed when retrofitting the
process control station with the interface board.
Enable parity bit
Parity odd
2 stop bits
Baud rate Modbus
300 bit/s
600 bit/s
1200 bit/s
2400 bit/s
4800 bit/s
9600 bit/s
19200 bit/s
Termination
Two-wire mode
Four-wire mode
20
Soldering jumper (LB)
PARITAET
UNGERADE
RES
Select a soldering jumper
300
600
1200
2400
4800
9600
19200
BUSABSCHLUSS (4 LBs)
2LEITER (2 LBs)
4LEITER (2 LBs)
Soldering jumpers
Default setting:
X closed, 0 open
0
0
0
0
0
0
0
0
X
0
0
0
X