Technical Specifications Of The Cp 440 - Siemens SIMATIC CP 440 Manual

Technical Specifications
A.1

Technical Specifications of the CP 440

General Technical Specifications
The following table contains the general technical specifications of the CP 440.
You will find the technical specifications of the function blocks in Section 6.7.
You will find further general technical specifications of the SIMATIC S7-400 in the
S7-400 and M7-400 Programmable Controllers, Module Specifications reference
manual, Chapter 1, "General Technical Specifications", and the S7-400 and
M7-400 Programmable Controllers, Module Specifications manual.
Electronic compatibility
Shipping and storage conditions
Mechanical and climatic environmental conditions
Information on insulation testing, safety class and degrees of protection
Standards, certificates and approvals
Technical Specifications
Dimensions W
Weight
Power input from backplane bus
Power loss
Indicators
Diagnostic functions
Indicators for internal and external
faults
Diagnostics information dump
Protocol drivers available
Transmission rate with the 3964(R)
protocol
Transmission rate with the ASCII
driver
Character frame
A-2
H D 29
0.3 kg
Max. 0.36 A at 5 V, typically 0.33 A at 5 V
Max. 1.9 W, typically 1.7 W
LEDs for transmit (TXD), receive (RXD) and
interface fault (FAULT) Group alarm LEDs for
internal fault (INTF) and external fault (EXTF)
Yes, 2 red LEDs
Yes
ASCII driver
3964(R) procedure
300, 600, 1200, 2400, 4800, 9600, 19200, 38400,
57600, 76800, 115200 bps
300, 600, 1200, 2400, 4800, 9600, 19200, 38400,
57600, 76800, 115200 bps
Number of bits per character (7 or 8)
Number of start/stop bits (1 or 2)
Parity (none, even, odd); at 7 bits per character,
only "even" or "odd" can be set for parity.
Point-to-point connection CP 440 Installation and Parameter Assignment
290 210 mm
A5E00057742-02