Differential Signal Data Pins; Configuration/Programming Pins; Control Pins; Power And Ground Pins - Denon DVD-2910 Service Manual

Dvd audio-video / super audio cd player
Hide thumbs Also See for DVD-2910:
Table of Contents

Advertisement

Differential Signal Data Pins

Pin Name
Pin #
TX0+
25
TX0-
24
TX1+
28
TX1-
27
TX2+
31
TX2-
30
TXC+
22
TXC-
21
EXT_SWING
19

Configuration/Programming Pins

Pin Name
Pin #
MSEN
11
RESERVED
34
NC
7,8

Control Pins

These control pins allow configuration of the transmitter through the slave I
Pin Name
Pin #
ISEL/RST#
13
SCLS
15
SDAS
14
CTL3
6
HTPLG
9

Power and Ground Pins

Pin Name
Pin #
VCC
1,12,33
GND
16,35,64
AVCC
23,29
AGND
20,26,32
PVCC1
18
PVCC2
49
PGND1
17
PGND2
48
Type
Description
Analog
TMDS Low Voltage Differential Signal output data pairs.
Analog
These pins are tri-stated when PD# is asserted.
Analog
Analog
Analog
Analog
Analog
TMDS Low Voltage Differential Signal output clock pairs.
Analog
These pins are tri-stated when PD# is asserted.
Analog Voltage Swing Adjust. A resistor should tie this pin to AVCC. This resistor
determines the amplitude of the voltage swing. A 510 ohm resistor is
recommended for remote display applications. For notebook computers, 680 ohm
is recommended.
Type
Description
Out
Monitor Sense. This pin is an open collector output. The output is programmable
2
through the I
C interface (see I
resistor is required on this pin.
In
This pin is reserved.
NC
These pins are not electrically connected inside the package.
Type
Description
2
In
I
C Interface Select. If HIGH, then the I
2
In
DDC I
C Clock.
2
In/Out DDC I
C Data.
In
External CTL3.
In
Monitor Charge Input. This pin is used to connect to the DVI Hot Plug pin to detect
the presence of an attached monitor.
Type Description
Power
Digital VCC. Connect to 3.3V supply.
Ground
Digital GND.
Power
Analog VCC. Connect to 3.3V supply.
Ground
Analog GND.
Power
Primary PLL Analog VCC. Connect to regulated 3.3V supply.
Power
Filter PLL Analog VCC. Connect to regulated 3.3V supply.
Ground
PLL Analog GND.
Ground
PLL Analog GND.
2
C register definitions). An external 5K pull-up
2
C port, which is required by HDCP.
2
C interface is active.
61
DVD-2910/955

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvd-955

Table of Contents