Adv7310 (Ic701,710); Adv7300 (Ma: Ic706); Adv7310 Terminal Function - Denon DVD-2910 Service Manual

ADV7310 (IC701,710)

ADV7300 (MA: IC706)

ADV7310 Terminal Function

Pin No. Pin Name
1 V
DD_IO
2~9, 12, 13 Y9-0
10, 56 V
DD
11, 57 DGND
14~18, 26~30 C9-0
19 SPI/I2C
20 ALSB_SO
21 SDA_CLKSP
22 SCLK_SI
23 P_HSYNC
24 P_VSYNC
25 P_BLANK
31 RTC_SCR_TR
32 CLKIN_A
33 RESET
34 EXT_LF
35, 47 R
SET1,2
36,45 COMP
37 DAC F
38 DAC E
39 DAC D
40 AGND
41 V
AA
42 DAC C
43 DAC B
44 DAC A
46 V
REF
48 S_BLANK
49 S_VSYNC
50 S_HSYNC
51~55, 58~62 S9-S0
63 CLKIN_B
64 GND_IO
VDD_IO 1
Y0 2
Y1 3
Y2 4
Y3 5
Y4 6
Y5 7
TOP VIEW
Y6 8
Y7 9
VDD 10
DGND 11
Y8 12
Y9 13
C0 14
C1 15
C2 16
I/O
P Digital power supply.
I 10-Bit Progressive scan/ HDTV input port for Y data.
P Digital power supply.
G Digital Ground
I 10-Bit Progressive scan/ HDTV input port for CrCb color data in 4:2:2 input mode.
When this input pin is brought low, the ADV7300 interfaces over the SPI port and uses this
I input as part of the 4 wire SPI interface. When this input pin is tied high [VDD_IO], the ADV7300
interfaces over the I2C port.
I/O Multifunctional pin.
I/O Multifunctional pin.
I Multifunctional input.
Video Horizontal Sync Control Signal for HD sync in simultaneous SD/HD mode
I
and HD only mode.
Video Vertical Sync Control Signal for HD sync in simultaneous SD/HD mode
I
and HD only mode.
I Video Blanking Control Signal for HD sync in simultaneous SD/HD mode and HD only mode.
I Multifunctional input.
I Pixel Clock Input for HD only or SD only modes.
This input resets the on-chip timing generator and sets the ADV7300 into Default Register
I
setting. Reset is an active low signal.
I External Loop filter for the internal PLL.
A1520 Ohms resistor must be connected from this pin to AGND and is used to control the
I
amplitudes of the DAC outputs.
O Compensation Pin for DACs.
In SD only mode: Chroma/RED/V analog output.
O
In HD only mode and simultaneus HD/SD: Pb/ BLUE (HD) analog output.
In SD only mode: Luma/BLUE/U analog output.
O
In HD only mode and simultaneus HD/SD: Pr/ RED (HD) analog output.
In SD only mode: CVBS/GREEN/Y analog output.
O
In HD only mode and simultaneus HD/SD: Y/ GREEN (HD) analog output.
G Analog Ground
P Analog power supply.
O Chroma/ RED/ V SD analog output.
O Luma/ BLUE/ U SD analog output.
O CVBS/ GREEN/ Y SD analog output.
I/O Optional External Voltage Reference Input for DACs or Voltage Reference Output (1.235V).
I/O Video Blanking Control Signal for SD.
I/O Video Vertical Sync Control Signal for SD.
I/O Video Horizontal Control Signal for SD.
10-Bit Standard Definition input port. Or Progressive Scan/ HDTV input port for
I
Cr [Red/V] color data in 4:4:4 input mode.
I Pixel Clock Input.
G Digital Ground
48 S_BLANK
47 R
SET 1
46 VREF
45 COMP1
44 DAC A
43 DAC B
42 DAC C
41 VAA
40 AGND
39 DAC D
38 DAC E
37 DAC F
36 COMP2
35 R
SET 2
34 EXT_LF
33 RESET
Function
58
DVD-2910/955