NOTE FOR SCHEMATIC DIAGRAM
1. WARNING:
Parts marked with this symbol
istics.
Use ONLY replacement parts recommended by the manu-
facturer.
2. CAUTION:
Before returning the unit to the customer, make sure you
make either (1) a leakage current check or (2) a line to
chassis resistance check. If the leakage current exceeds
0.5 milliamps, or if the resistance from chassis to either
side of the power cord is less than 460 kohms, the unit is
defective.
3. WARNING:
DO NOT return the unit to the customer until the problem
is located and corrected.
4. NOTICE
ALL RESISTANCE VALUES IN OHM. k=1,000 OHM
M=1,000,000 OHM
ALL CAPACITANCE VALUES IN MICRO FARAD.
p=MICRO-MICRO FARAD
EACH VOLTAGE AND CURRENT ARE MEASURED AT
NO SIGNAL INPUT CONDITION.
CIRCUIT AND PARTS ARE SUBJECT TO CHANGE
WITHOUT PRIOR NOTICE.
SIGNAL LINE
have critical character-
SIGNAL LINE
28
DN-V200 / V300
µ